L3+ hash rate is low or a hash board is faulty

Please try to reload the firmware:

https://shop.bitmain.com/support.htm?pid=00720170915192851224mJ36J1ap066E

Run the miner for 20 minutes after reloading the firmware.

Please check the power supply and controller first.

To check the power supply, you can use a well-functioning power supply to test the miner. If you don't have another PSU, you can also check by switching the cables between the hash boards. If the problem is with the cable, the power supply may be faulty.

To test the control board, switch the controller cable between the hash boards. If the same hash board shows the issue then the hash board is faulty. If the issue follows the cable then the controller may be faulty.

If it is still not resolved, please test each hash board separately to determine which hash board has failed.

To test each hash board separately: keep the power supply connector of one hash board connected to the control board cable, and disconnect the cables on the other two hash boards. With the operation of the miner, you can see the status of the connected hash board.

Here is more detail:

https://zeusbtc.com/articles/asic-miner-troubleshooting/1050-how-to-test-antminer-hash-board-one-by-one

On the miner status screen defective chips are displayed as "xxx", "---" or " ASIC≠60.


0
About products purchase, please contact our sales manager:
[email protected]

About miner repair and after-sale issues, please contact the repair manager email:
[email protected]

For business cooperation, please contact:
[email protected]

COMPLAINTS & SUGGESTIONS
If you have any dissatisfaction during the transaction or have valuable suggestions for us, please contact us via this email address:
[email protected]
Attention!

Recently, many companies claiming to be mining companies imitate us and say that they are related to us, or that they are our branch companies, which has caused customers to be deceived. Please be careful not to believe any impostors, please check our correct contact information and beware of being deceived getting scammed, and losing money.
please check our right contact way: Here

CLOSE