Power cord replacement steps for Avalon A1466 miner PSU3500-01

The PSU3500-01 power cord is suitable for Avalon 14, and 15 series air-cooled miners, such as A1446, A1466, A1566, etc. It is made of high-quality materials, 2.5mm² wire diameter, 150cm length. It offers strong conductivity, high insulation properties, high-resistance to plugging and unplugging. One end connects to the PSU3500-01 power supply, while the other end connects to a PDU or power socket, ensuring stable power to the miner. Additionally, it supports customized plugs for C20, US, UK, and EU, meeting the needs of different countries.

Factors such as excessive voltage, high current, and circuit aging can damage the power cord, resulting in unstable or interrupted current transmission, directly affecting the machine's startup and operation, thus reducing its mining efficiency. Furthermore, voltage fluctuations can impose additional burdens on miner, shortening its service life. If faulty components are not replaced promptly, electrical safety risks such as short circuits and electric shocks may occur, potentially leading to equipment damage or fires. Therefore, we must attach great importance to the safety of power cord, regularly inspect, timely replace the faulty one to ensure the machine's normal operation and the miners' safety.

Replacement steps:

1. Disconnect the faulty PSU cord:

● Turn off the miner, then disconnect its power cord from the PDU or socket to ensure complete power cutoff, avoiding the risk of electric shock.

● Locate the miner's power supply interface to carefully unplug the power cord.

2. Install the new PSU cord:

● Inspect the new PSU3500-01 power cord to ensure it has no damaged outer skin, exposed wires, and that its interface type matches the original.

● Connect one end of the PSU cord to the PSU3500-01 power supply and the other end to the PDU or power socket, ensuring a secure connection.

● Carefully check all connections to ensure there are no loose or poor contacts. Finally, power to the miner, then observe its operating status.

Note: Keep the power cord in a natural state to avoid long-term excessive pulling, bending, and repeated plugging and unplugging, which may damage it, affecting the performance of the miner. If the cable is burned due to a fault inside the machine, please repair them first before replacing the new one.

Timely replacing faulty power cords can not only ensure the continuous and stable operation of miners but also effectively extend their service life, creating greater value for the mining business.