Whatsminer P222B PSU is specifically designed to replace the faulty power supply in Whatsminer series miners, aiming to quickly restore their operation and avoid additional losses caused by downtime. It provides a stable voltage output of 12-14.5V, ensuring efficient operation of the machine, especially suitable for Whatsminer M30, M50, and M60 series air-cooled miners, including M60, M60S, M30S++, M50, M50S, M50S+, M50S++, M30S, M30S+, etc.
As the "heart" of the miner, the power supply is responsible for providing stable powering support for its internal components. Once it is damaged, the device will fail to start, frequently restart, or suddenly power off during operation, seriously affecting its mining efficiency. At this time, we should immediately replace the new Whatsminer P222B PSU to resume miners' normal operation quickly, thus ensuring the stable income of miners.
The replacement steps for Whatsminer M60 miner P222B PSU are as follows:
1. Remove the faulty PSU
• Turn off the power to the miner, unplug the cooling fan plug of the air inlet, and then remove the fixing screws of the protective cover plate above the control board to remove it.
• Unplug the power cable connected to the control board, then remove the fixing screws of the adapter plate and conductive copper sheet.
• Remove the inlet fan, next take off the adapter plate.
• Unscrew the fixing screws of the power supply, after unplugging the outlet fan connector, carefully remove the faulty one.
2. Install the new PSU
• Carefully check the appearance and label of the new P222B power supply to ensure that the model is compatible with the miner and is not damaged.
• Align the new PSU with the screw holes on both sides and then tighten the fixing screws.
• Insert the outlet fan plug, tighten the fixing screws of the conductive copper sheet, and install the inlet fan.
• Fix the adapter plate, connect the PSU plug to the control board, tighten the fixing screws of the protective cover plate, and then connect the air inlet fan plug to complete the replacement.
3. Operation test
• Power on the miner to start. Carefully observe its operating status to ensure that the new power supply can provide stable powering.
Through the above steps, we can easily replace the new P222B PSU for Whatsminer M60 miner, ensuring that it can quickly resume normal operation and continue to bring stable mining revenue.