The Iceriver KS1 and KS2 power output wires connect the miner's control board to the PSU, ensuring a stable power feed. These cables carry high power loads, meeting the miners' electrical demands under high hash rates, maintaining equipment stability and safety during extended mining sessions.
A faulty power supply output wire will directly lead to powering interruptions or instability, affecting operational efficiency and potentially damaging equipment while posing safety hazards. Therefore, once a fault is detected, it is imperative to immediately shut down the miner, inspect, then replace the cable.
Replacement steps for Iceriver KS1 and KS2 power output wires:
1.Turn off the power, use a screwdriver to remove the screws on the control board and the PSU protective cover, then detach the shell.
2.Locate the output cable connecting the control board and PSU, then carefully unplug it without damaging the hardware interfaces.
3.Prepare the new power output cable, connecting the left-end interface to the control board and the right 2 cables port to the PSU.
4.After confirming that the cable is securely connected, reinstall the protective cover and tighten the screws.
Note: When replacing the power supply output wires, ensure power is fully disconnected and proper insulation is in place. Maintain a dry and clean work environment to prevent excessive temperature, humidity from affecting the circuitry.
Replacing the power output wires of Iceriver KS1 and KS2 aims to ensure miners receive optimal power delivery, thereby extending the equipment's lifespan. The output power cables effectively minimize power fluctuations and overheating risks, preventing data loss and miner damage caused by unstable power, which ultimately reduces long-term maintenance costs , then ensures the miners' continuous and efficient operation.